Hello, thank you for this post, maybe someone can help me with my configuration, i have connected my bafang with a usb-can-interface and was able to read the can-communication but i did non found the adresses or packets you wrote about.

(and i am not sure where the jumper on the interface is for, but without the jumper it does not work, i can’t read the communication, with the jumper it stops after several seconds and the DP C080.CB shuts down, when i start without the jumper and put it later in, then it works for a longer time)

The parts work great, but i am not abled to drive more than ~30 km/h

in the DP C080.CB i configured:

20 inch wheel size (which fits my wheels)
1580mm diameter
60 km/h
the speed shown while driving seems correct

the parts are:
MM G340 (750watt)
DP C080.CB

here is the can output: (I deleted the duplicate lines)
https://pastebin.com/YCS9fV5R

i connected the DP C080.CB with the bafang-go app, i’m not sure where the limitations comes from, the motor or the DP C080.CB ?

thanks in advance!